Metal distribution in incineration residues of municipal solid waste (MSW) in Japan

This study aimed to identify distribution of metals and the influential factors on metal concentrations in incineration residues. Bottom ash and fly ash were sampled from 19 stoker and seven fluidized bed incinerators, which were selected to have a variety of furnace capacity, furnace temperature, and input waste. In the results, shredded bulky waste in input waste increased the concentration of some metals, such as Cd and Pb, and the effect was confirmed by analysis of shredded bulky waste. During MSW incineration, lithophilic metals such as Fe, Cu, Cr, and Al remained mainly in the bottom ash while Cd volatilized from the furnace and condensed to the fly ash. About two thirds of Pb and Zn was found in the bottom ash despite their high volatility. Finally, based on the results obtained in this study, the amount of metal in incineration residues of MSW was calculated and the loss of metal was estimated in terms of mass and money. A considerable amount of metal was found to be lost as waste material by landfilling of incineration residues.     

EPR characterization of the catalytic activity of clays for PCE removal by gamma-radiation induced by acid and thermal treatments

Clays from tidal flat sediments showed efficient catalytic activity in the decomposition of PCE by gamma-radiation. The highest PCE removal of 98.6% was obtained with clays heated to 700 degrees C after acid treatment. The improved catalytic activity was identified by electron paramagnetic resonance (EPR) spectroscopy. The EPR spectra of clays were significantly changed by the acid and thermal treatments. The intensity of a narrow signal at g=2 (signal III) was decreased with increasing thermal treatment temperature and this increased the PCE removal efficiency. The acid treatment completely removed a broad signal at g=2 (signal II), decreased the intensity of signal III, and improved the gamma-radiation treatment of PCE.     

Selective leaching of valuable metals from waste printed circuit boards

This study was carried out to recover valuable metals from the printed circuit boards (PCBs) of waste computers. PCB samples were crushed to smaller than 1 mm by a shredder and initially separated into 30% conducting and 70% nonconducting materials by an electrostatic separator. The conducting materials, which contained the valuable metals, were then used as the feed material for magnetic separation, where it was found that 42% of the conducting materials were magnetic and 58% were nonmagnetic. Leaching of the nonmagnetic component using 2 M H2SO4 and 0.2 M H2O2 at 85 degrees C for 12 hr resulted in greater than 95% extraction of Cu, Fe, Zn, Ni, and Al. Au and Ag were extracted at 40 degrees C with a leaching solution of 0.2 M (NH4)2S2O3, 0.02 M CuSO4, and 0.4 M NH4OH, which resulted in recovery of more than 95% of the Au within 48 hr and 100% of the Ag within 24 hr. The residues were next reacted with a 2 M NaCl solution to leach out Pb, which took place within 2 hr at room temperature.     

Supported Pd/Sn bimetallic nanoparticles for reductive dechlorination of aqueous trichloroethylene

A Pd/Sn bimetallic nanoparticles resin (nano-Pd/Sn/resin) was successfully synthesized for reductive transformation of aqueous trichloroethylene (TCE). The physicochemical properties of the prepared resin were characterized using scanning electron microscopy, energy dispersive X-ray spectroscopy, N(2) isothermal sorption at and X-ray photospectroscopy. The surface-area-normalized rate constants (k(SA)) of Sn particles in the nanoscale range (50-100 nm) were 4.5 times larger than the k(SA) for powdered Sn (0.04 mm). After depositing 1 wt% Pd onto nano-Sn surface, k(SA) was further enhanced by about a factor of 2. Groundwater constituents such as sulfide nitrate and dissolved oxygen had significant negative effects on the rate of TCE degradation by the nano-Pd/Sn/resin. A wet-chemical method regeneration method was observed to effectively restore the reactivity of the poisoned nano-Pd/Sn/resin after dipping in sulfide solution for 2d. In all cases, less than 0.5% of the degraded TCE appeared as chlorinated byproducts including the three dichloroethene isomers. The nano-Pd/Sn/resin technique performs well in transforming TCE into nontoxic hydrocarbons, as compared with other published methods.     

Thermodynamic behavior of rare metals in the melting process of municipal solid waste (MSW) incineration residues

This study aims to identify the thermodynamic behavior of rare metal elements during the melting process of municipal solid waste incineration residues. The fate of several selected rare metal elements was investigated using two approaches: experimental and thermodynamic equilibrium calculation at two actual melting plants. The results revealed that Ag, Bi, Ga, Ge, In, Pd, Sb, Te, and Tl are readily volatilized as chloride and/or gaseous forms and then condensed in melting furnace fly ash. On the other hand, Cr, Ni, Ta, V, and Zr tend to mostly remain in molten slag. Sn is volatilized as SnS (g) under reducing conditions while volatilization is suppressed under oxidizing conditions. Thermodynamically, total volatilization of Mn as MnCl2 (g) occurred with highly available chlorine under oxidizing conditions. However, at the actual plants, only a small proportion was volatilized. As for Co, Mo, and W, no volatilization occurred at the actual plants although the calculations suggest that these elements can form volatile metal chloride and volatilize. Non-equilibrium and heterogeneity of the actual plant melting furnace could explain the discrepancy. This study provided a good qualitative view of the behavior of rare metals in the melting process, but further investigation is required to produce a more accurate simulation and to resolve the discrepancy.     

Chemical characteristics of fine particulate matters measured during severe winter haze events in Ulaanbaatar,Mongolia

In order to investigate the chemical characteristics of atmospheric aerosol measured during a severe winter haze event, 12-hr PM_2.5 (particulate matter with an aerodynamic diameter ≤2.5 μm) samples were collected at an urban site in Ulaanbaatar, Mongolia, from January 9 to February 17, 2008. On average, 12-hr PM_2.5 mass concentration was 105.1 ± 34.9 μg/m³. Low PM_2.5 mass concentrations were measured when low pressure developed over central Mongolia. The 12-hr average organic mass by carbon (OMC) varied from 6.4 to 132.3 μg/m³, with a mean of 54.9 ± 25.4 μg/m³, whereas elemental carbon (EC) concentration ranged from 0.1 to 3.6 μgC/m³, with a mean of 1.5 ± 0.8 μgC/m³. Ammonium sulfate was found to be the most abundant water-soluble ionic component in Ulaanbaatar during the sampling period, with an average concentration of 11.3 ± 5.0 μg/m³. In order to characterize the effect of air mass pathway on fine particulate matter characteristics, 5-day back-trajectory analysis was conducted, using the Hybrid Single-Particle Lagrangian Integrated Trajectory (HYSPLIT) model. The haze level was classified into three categories, based on the 5-day air mass back trajectories, as Stagnant (ST), Continental (CT), and Low Pressure (LP) cases. PM_2.5 mass concentration during the Stagnant condition was approximately 2.5 times higher than that during the Low Pressure condition, mainly due to increased pollutant concentration of OMC and secondary ammonium sulfate.

Implications: Mongolia is experiencing rapid rates of urbanization similar to other Asian countries, resulting in air pollution problems by the growing number of automobiles and industrialization. Ulaanbaatar, capital of Mongolia, is inherently vulnerable to air pollution because of its emission sources, topography, and meteorological characteristics. Very limited measurements on chemical characteristics of particulate matter have been carried out in Ulaanbaatar, Mongolia.     

Spectroscopic Distribution of Dissolved Organic Matter in a Dam Reservoir Impacted by Turbid Storm Runoff

Spectroscopic characteristics of dissolved organic matter (DOM) in a large dam reservoir were determined using ultraviolet absorbance and fluorescence spectroscopy to investigate spatial distribution of DOM composition after turbid storm runoff. Water samples were collected along a longitudinal axis of the reservoir at three to four depths after a severe storm runoff. Vertical profiles of turbidity data showed that a turbid water layer was located at a middle depth of the entire reservoir. The spectroscopic characteristics of DOM samples in the turbid water layer were similar to those of terrestrial DOM, as demonstrated by the higher specific UV absorbance (SUVA) and the lower fluorescence emission intensity ratio (F ₄₅₀/F ₅₀₀) compared to other surrounding DOM samples in the reservoir. Synchronous fluorescence spectroscopy revealed that higher content of humic-like DOM composition was contained in the turbid water. Fluorescence excitation–emission matrix (EEM) showed that lower content of protein-like aromatic amino acids was present in the turbid water DOM. The highest protein-like fluorescence was typically observed at a bottom layer of each sampling location. The bottom water DOM exhibited extremely high protein-like florescence near the dam site. The particular observation was attributed to the low water temperature and the isolation of the local bottom water due to the upper location of the withdrawal outlet near the dam. Our results suggest that the distribution of DOM composition in a dam reservoir is strongly influenced by the outflow operation, such as selective withdrawal, as well as terrestrial-origin DOM inputs from storm runoff.     

Wastewater treatment plants (WWTPs) as a source of sediment contamination by toxic organic pollutants and fecal sterols in a semi-enclosed bay in Korea

Toxic organic contaminants and a macrobenthic community were assayed in sediments collected near a wastewater treatment plant (WWTP) outfall to assess the impact of WWTP discharges on an aquatic environment. Average concentrations of toxic organic contaminants in sediments from 20 locations were 96.7ng TEQ/kg dry matter for PCDD/Fs, 1.84ng TEQ/kg dry matter for dioxin-like PCBs, 29.1microg/kg dry matter for PBDEs, 411microg/kg dry matter for nonylphenols, 1021microg/kg dry matter for fecal sterols, and 928microg/kg dry matter for PAHs. Concentrations of all the organic contaminants and fecal sterols varied widely and there was a clear decrease in concentration gradients with increasing distances from the WWTP outfall. This result suggests that WWTP activities contribute to contamination by organic chemicals. A survey of benthic organisms showed the dominance of a few polychaete species, indicating a deterioration of the macrobenthic community by the WWTP discharge. Non-parametric multidimensional scaling (MDS) ordination and Spearman correlation analyses showed that organic contamination is associated with the benthic community structure. For polychaete species, the sensitive species for organic contaminants was Paraprionospio pinnata, while contaminant-tolerant species were Spiochaetopterus koreana and Capitella capitata. BIOENV analyses of all locations suggested PCDDs and PCDFs as the major contaminants influencing the structure of the macrobenthic community. The present study highlights that continuous WWTP discharges contribute to severe organic contamination and risks for the benthic community in an aquatic ecosystem.